There is no building instructions, I had to wing it, but it's pretty straight forward ... except for those darn strips! No-one can figure out what to do with the stupid things, and this has been an ongoing topic of conversation on many papercraft forums.
What I did was to cut off the tabs on the strips and glue them directly onto the face of the cube - still looks pretty cool
What I did was to cut off the tabs on the strips and glue them directly onto the face of the cube - still looks pretty cool
Figured out how the pink strips work. The original original model was a hat and it was quite a bit bigger so that would make the strips much easier. It does require cutting 2 or 3 mm into the 4 face segments and then folding the tabs down. The tabs on the strips fold up and glue under the tiny tabs on the face.
I had to measure them all because the natural spot is hard to see. And lots of careful scoring lines. It creates a pretty wicked effect.
I had to measure them all because the natural spot is hard to see. And lots of careful scoring lines. It creates a pretty wicked effect.
I hope you submit a photo here - I really would like to see it!
Guess I'm gonna do this, then. At least all the rest is 3D!
Good luck, and don't forget to send me a link when you finish it and submit it to DA